 |
|
| |
...continued |
|
|
Installation instructions on the complete system and a Listed cap must be used in a Wet Location. Igloo cap must be used if the correct 1 1/2" spacing in the enclosure cannot be maintained. |
 |
Listed cap |
 |
Igloo cap |
|
|
|
|
|
Westrim boot |
Boot and sleeve assemblies must be assembled per their manufacturers' installation instructions;
NOTE: Manufacturers parts are NOT interchangeable.
Masters lighting components not shown |
Electrobits boots |
|
Masters boot |
Installation instructions on the complete system must be used in a wet location
Refer to: www.masterstechnology.com |
|
|
PK housing shown
Through wall
Picture shows the bonding requirements to maintain continuity in the system because of the two rubber seal washers required.
Installation instructions for PK housings can be found at:
www.westrimproducts.com |
 |
|
|
|
|
|
|
|
About: |
|
|
©2006-2013 NeonInstallationGuide.com
|
